Descargar Imprimir esta página

Sennheiser EK 3053-U Instrucciones Para El Uso página 11

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 27
¹
5
Battery or accupack operation
The EK 3053-U can be powered by either batteries or rechargeable
accupacks. We recommend using a 9 V PP3 battery (IEC 6 LR 61). If
powered by a 9 V PP3 battery, the receiver has an operating time of
approx. five hours with the volume set to a medium value. Since the
power consumption depends to a large extent on the volume adjustment
on the EK 3053-U, the operating time will be reduced by up to 30 % if
the volume is set to a high value. The operating time can be increased
by up to 20 % if you choose a low volume. If the receiver is operated
with a rechargeable 9 V accupack, the operating time will be reduced
to less than two hours.
6
Inserting / Changing the battery
Slide the cover of the battery compartment
of the receiver, then open the cover. Insert the 9 V PP3 battery as shown
above. Close the battery compartment by carrying out the operating
steps in reverse order.
To remove the battery, push the small lever
compartment towards the bottom side of the receiver.
Note
Please observe correct polarity when inserting the battery!
7
Connecting the antenna
Screw the supplied antenna onto the Lemo socket
U.
20
towards the bottom side
¹
in the battery
³
on the EK 3053-
8
Connecting the headphones
Connect the headphones to the 3.5 mm Ø stereo jack
3053-U. If you use the receiver as part of the in-ear monitoring system,
please connect in-ear headphones. If you use the receiver for other
applications, you can also connect any Sennheiser stereo headphones.
Note
Only connect headphones with a stereo jack plug to the
3.5 mm Ø stereo jack ·!
9
Setting the receiving frequency
Slide back the coverplate ¾. Use the channel selector switch
the desired receiving frequency. The assignment of a switch position to
a frequency is listed on the type plate on the back of the receiver. Up to
16 receiving frequencies are available.
Note
Transmitter and receiver must be set to the same
frequency!
10
Switching the receiver on
»
Turn the volume control
clockwise (the volume control has an inte-
gral on/off switch - the receiver is switched off when the control is
turned fully anti-clockwise until it clicks).
·
on the EK
to set
21

Publicidad

Capítulos

loading