Blue Lagoon SPA UV-C 12 WATT Manual De Instrucciones página 4

BLUE LAGOON SPA UV-C 12 & 15 WAT T
OPERATION
EN
The special Philips UV-C lamp in the Blue Lagoon Spa UV-C generates UV-C radiation with a
wavelength of 253.7 nm, and this ensures the destruction of bacteria, moulds and viruses. This lamp
has been specially designed by Philips, and is ideal for water temperatures up to 40 degrees Celsius.
The Blue Lagoon Spa UV-C ensures fresh, clean and clear water in an efficient and environmentally-
friendly manner. The water is guided through the UV-C device by means of a pump. The
UV-C radiation neutralises bacteria, viruses and other primitive organisms and prevents their
reproduction. The Blue Lagoon Spa UV-C has an integrated electronic ballast. This ballast ensures
maximum lamp performances. In addition, the aluminium interior provides additional reflection
of the UV-C radiation, thereby increasing the efficiency up to 50%. Thanks to the Blue Lagoon Spa
UV-C, your water will be disinfected efficiently and safely, and the quality of your water will remain
excellent. Contains connecting pieces. The device can be connected using PVC tube or hose.
INSTALLATION OF THE UV-C DEVICE (DRAWING 1)
The ideal place for the installation of the device is immediately behind the filter. Never submerge
this device in water. Always install the device outside of the pool. Ensure that there is always water
flowing through the unit if the lamp is on.
1. Determine where the device will be installed. (always install vertically, see Drawing 3).
2. Fit the unit into the circuit using the three-part couplings (F).
3. Connect the end of the cable (D) to the top of the lamp (A).
4. Activate the pump and check the flow and any leakage of the system.
5. Insert the plug of the UV-C device into a wall socket with a safety ground and fitted with an residual
current circuit-breaker (max 30 mA). Check that the lamp is on by looking through the transparent
components of the device. The unit is switched off by pulling the plug out of the socket.
DISMANTLING/MAINTENANCE
Always switch off the power supply while maintaining/dismantling the device.
The device must be cleaned twice a year. If there is an increase in pollution, the quartz glass tube (B)
must be cleaned. The special lamp (A) must be replaced after 6,000 operating hours (± 1x a year) at
the latest. The aluminium interior can be cleaned with a soft brush.
1. Unscrew the three-part couplings (F) and drain the water from the device.
2. Click the black fastening clip (H) from the screw ring (E) using a screw driver, (see Drawing 3).
3. Unscrew the screw ring (E), remove the lamp from the quartz glass and, if necessary, replace the
special lamp (A). As these parts are very fragile, caution is essential.
4. Carefully remove the quartz glass (B) using a large, flat screwdriver (see Drawing 2). Never use force!
5. Clean the quartz glass with a suitable agent. Always use a soft cloth to clean the glass and
prevent scratches.
4 | BLUE LAGOON UV-C SPA 12 & 15 WATT
Please read carefully through these instructions
for use before installing this device.