Publicidad
Idiomas disponibles
Idiomas disponibles
20
Caroslide
Mounting on top of Turnout / Turnin with a BEV-seat
Remove the four bottom M8 nuts (A). Then drive back and forth to be able to reach
the screws.
Screw the four screws, either in the rear drill pattern or in the front drill pattern,
depending on what is required. Do NOT use the front drill pattern in vehicles with a
narrow door opening.
Using the front drill pattern would require a door opening of at least 650 mm, to be
able to swivel inside the vehicle with the rails in a max forward/out position when a
motor failure has occurred.
Drive Caroslide backwards. Remove the four upper M8 nuts (B), exchange the four
M8 screws for the enclosed M8x35 screws. Screw the BEV-seat onto the Caroslide.
A Recaro Specialist L seat can also be used, but in that case two holes must be drilled
in the rails and M6 screws must be used (not included).
The wiring diagram is found on page last page.
Publicidad
