Intended Use; Handling; Work Environment - Berner 1.06/1 Instrucciones De Manejo

1.3 Intended Use

The puller is designed to remove pulleys, ball bearings, gear wheels, and other
components from shafts and axles.
• DO NOT use the puller for any other purpose.
• MISUSE can lead to SERIOUS INJURY or DEATH.
• DO NOT allow children to use the puller.

1.4 Handling

ELECTRICAL SHOCK HAZARD. ALWAYS DISCONNECT electricity before
using the puller on or near electrical parts or circuits.
Take the following safety precautions to prevent injuries and damage caused by
improper handling and unsafe use of the puller:
Improper handling can result in SERIOUS INJURY or DEATH.
• ALWAYS check the puller for damage before use.
• ALWAYS replace damaged or worn parts before use.
• ALWAYS use only GEDORE original spare parts and accessories.
• NEVER use electric or pneumatic torque multipliers or impact wrenches.
• NEVER use electric, pneumatic, or percussion drivers.
• NEVER heat the puller.
• NEVER modify any parts of the puller, especially the pulling legs.
• NEVER bend over the part being pulled during the pulling process.
• DO NOT allow children to use the puller.

1.5 Work Environment

ALWAYS use the puller in a safe work environment.
• Keep the work area clean and tidy.
Use the puller in a large and secured area.
•
EN
5