Special Product Features; Transportation; Operating Elements - Metabo PK 200 Manual De Instrucciones Original

ENGLISH
teeth of the saw blade and being thrown
against the operator.
Always have riving knife installed during
operation.
Push stick
The push stick (14) serves as an exten-
sion of the hand and protects against
accidental contact with the saw blade.
Use push stick if distance rip fence –
saw blade is ≤ 120 mm.
In order for the push stick to be always
at hand, it can be stored in a sheath
inside the machine's housing.
14

4. Special Product Features

•
Precisely adjustable bevel tilt from –
1.5° through 46.5°.
•
Steplessly adjustable depth of cut 0
– 65 mm.
•
All operating elements are located
at the machine's front.
•
Electronic speed control:
− motor soft start;
− low mains supply load;
− constant saw blade speed irre-
spective of load provides for con-
sistent cut quality;
− extended service life of the car-
bon brushes;
− low no-load speed results in less
annoyance by noise.
•
An electronic motor protection by
overcurrent detection
motor off when it is locked (e.g. by a
blocked saw blade).
•
An undervoltage relay prevents the
machine from starting up when
power is restored after a power fail-
ure.
•
Compact design for quick and easy

transportation.

•
Mitre fence and rip fence are stand-
ard delivery.
16
5. Transportation
•
Lower saw blade fully.
•
Dismount add-on parts (fence, slid-
ing carriage, table extension).
•
If possible use original carton for
shipping.
A
Caution!
For carrying use the handle
holes at the sides of the machine. Do
not carry the machine holding it by
any of the safety devices or operating
elements!

6. Operating Elements

ON/OFF switch with emergency stop
•
To switch ON = depress upper but-
ton (15).
•
To switch OFF = push lower button
(16) or on switch cover.
3
Note:
Upon power failure an undervolt-
age relay is activated. This prevents the
starting of the machine when the power
is restored. To restart the saw after a
power failure the green switch button
(15) needs to be actuated again.
The ON/OFF switch can be blocked by a
padlock.
Handwheel for setting the depth of
cut
The depth of cut can be adjusted by
turning the handwheel (17).
shuts the
Handwheel for blade tilt setting
With the handwheel (18) the saw blade
can be steplessly tilted to the right from
0° (vertical) through 45°.
The centre of motion is at saw table
15
16
17
level, so the depth of cut remains the
same regardless of the bevel angle.
Ratchet lock lever
The set bevel angle can be locked with a
ratchet lock lever (19), so it does not
change during sawing.
3
Note:
There are several ratchet lock
levers on the saw. If the swivelling range
is not sufficient, the lever position can be
shifted:
pull lever up, turn and let engage again.
Lever, blade tilt limiter
The blade tilt setting has end stops at 0°
and 45°. For special bevel cuts (under-
cutting) the bevel angle
increased by 1.5° in both directions.
•
Blade tilt limiter (20) left (down) =
saw blade bevel angle adjustable
between 0° and 45°.
•
Blade tilt limiter (20) right (up) = saw
blade bevel angle
between –1.5° and 46.5°.
20
18
19
can be
adjustable