Safety Information - CALOR 5023 Manual Del Usuario

English
1 - DESCRIPTION (see exploded view) :
Your machine is composed of:
tub (A)
A plastic which has:
•
1two water level marks: the low water mark (1) indicates the
lowest acceptable water level for any size load (always fill to this
mark even if the load is small) and the high water mark (2)
indicates the highest level (water plus laundry) to which the
machine may be filled. It is important to use the right proportion of
water for the amount of laundry otherwise the laundry may not be
agitated vigorously enough,
•
1a drain orifice (3) at the bottom right of the machine to drain
water from the tub,
•
1an emptying system controlled by a drain handle (4) on the top
right of the machine.
In addition, on Model 50.40:
machine with a three-prong plug, an overheat switch and a floater to
p r event heater operation when the water level in the tub is too low
•
1An opening at the top centre of the machine to discharge water
during rinsing.
A motor unit (C),
which has:
•
1a motor with overheat protection that stops the motor in case of
accident, overheating or incorrect positioning; the motor will start
once parts have cooled (which may take up to 15 minutes),
•
1a power cord storage cassette.
In addition, on Models 50.23, 50.24, 50.33 and 50.40:
•
1a timer (16) and timer display (15) to automatically stop the
machine after the desired wash time.
On model 50.40:
•
1an ON/OFF switch (17) for the heater.
On Model 50.27:
•
1an automatic programmer (16) and programmer display (15) to
select any of three wash cycles,
• •
1pre-wash ; 1soak or ;
the machine stops automatically once the selected cycle is
complete.

2 - SAFETY INFORMATION

Voltage:
•
Models 50.23, 50.27 and 50.33: 220-240 V
•
Model 50.40: 230 V
•
Model 50.24 is dual voltage (115-127 V or 220-240 V).
•
Always make sure the voltage displayed at the back of the washing machine is appropriate for your power supply. If not, push the
toggle switch all the way to one side until the correct voltage is displayed.
•
ALWAYS CONNECT MODEL 50.40 TO A GROUNDED (THREE-HOLE) SOCKET.
•
1A heater (5) on the left of the
•
1wash and single, double or triple rinse;
Important:
•
Never operate the washing machine unless it contains sufficient water.
•
Unplug the washing machine before removing the motor unit.
•
Never fill the tub with flammable liquid.
washing unit (B)
An easy-to-remove
•
1a rotor plate (8) and roller track (7),
•
1a roller ring with six rollers (9),
•
1a rotor (10), the large rotating plate under the tub; the
shape of the raised cross on the rotor has been designed
specifically for gentle washing by combining a slow tumble
and alternating spin motion,
•
1a partition (11) to isolate the drive shaft (12) and pinion
(13).
A lid (D)
with viewing window (window not on all models).
A fill hose (E
) and hose end-piece (F).
which has: