FRIGOGLASS MAX-450 [R290] C Manual De Usuario página 11

ENG
adjustment of the leveling feet in all installations. It must be ensured that the cooler does not
exhibit any inclination towards its front side and/or its lateral sides, after adjustment. A slight
inclination toward its back side will further facilitate the good circulation of the fluid and support
the door closing mechanism. The use of a spirit level is highly advisable to check leveling. Verify
that the cooler sits firmly on the leveling feet. The front cooler wheels (if available) should be
able to rotate by hand after cooler installation and adjustment. There are 2 or 3 (depending on
the size) adjustable feet for all models at the front under the chassis. The level foot must be
adjusted in such a way that the lower edges of the internal cabin are aligned. The below given
check points must be on the same line.
When the cooler has small rotating castor wheels (optional feature) the brake must always be
applied when cooler is at the final position.
CASTOR BREAKS
MUST BE APPLIED
AT ALL TIMES WHEN
THE COOLER IS AT
THE FINAL POSITION
Take necessary precautions if lifting is needed during installation. Keep unauthorised people
away from the cooler until installation is completed.
iii. The merchandiser must stand upright for at least 1 hour after transportation and prior to start-up.
This gives the oil time to run back to the compressor after transit and installation.
iv. Allow a minimum gap of 100mm at the top, 100mm at the rear and 50mm at the sides of the
cooler for proper ventilation.
v. Do not place anything on top of the cooler.
11
Check points
Level foot at the
middle