SCHOTT EasyLED Manual De Instrucciones página 20

EasyLED - Operating Instructions
To avoid unnecessary strain on the object by illuminating with visible light, reduce the
brightness and duration of illumination to the absolute minimum level required!
The instruments may be operated only with the power supply unit specified by SCHOTT and
only within the designated mains voltage range. Otherwise, trouble-free operation and
conformity with applicable standards cannot be guaranteed!
The illumination units have been designed for operation in dry and dust-free interior rooms
only!
The system must not be used in explosive areas!
Safe disconnection from the power supply is only guaranteed by pulling out the mains plug!
When setting up, dismantling and converting the system, always switch off the instruments
and pull the power plug!
Never open or dismantle power supply units or illumination units. Refrain from performing
any technical modifications. Repairs may only be carried out by the manufacturer or by its
authorised customer service agencies.
Please ensure that every user of the system has quick access to these operating
instructions!
The manufacturer is not liable for damage caused by failure to obey these instructions.
Notes on operating the Transmitted Light Stage:
The transmitted light stage has been developed for operation in a microscope stand or in
another metallic heat sink.
If the transmitted light stage is operated without the heat sink, the metal housing can heat up
to approx. 50°C. However, the diffuser disc and the specimen field do not heat up to the
same level.
While causing an unpleasant sensation, the housing temperature mentioned above does not
impair technical safety. The operation of the illumination is not affected in any way.
6/13