1
Use a size 10 socket spanner to loosen the screw on the back of the square winding pin. Take out the
screw and the washer.
Front of the winding pin – cover side (15 x 15mm)
Winding pin
Place your WALU COOL on a stable, flat surface.
2
a) Push the 13mm square side of the pin into the WALU COOL reduction gear as far as it will go.
b) Put back the washer and screw on the back of the square winding pin from the opposite side and screw
up firmly using the socket spanner to ensure the square pin is locked into the motorised mechanism.
a)
After fully charging the battery (see instructions for use, page 4/4),
3
your WALU COOL is ready for use.
* Optional for covers equipped with a 13 x 13 mm square winding pin
Thank you for choosing WALU COOL to wind
your swimming pool cover.
FITTING THE SQUARE WINDING PIN*
Installation instructions
Stop pin
Back of the pin – WALU COOL side (13 x13mm)
b)
2/4
Screw
Washer