Rebel RB-1060 Manual De Usuario página 37

Switching the power tool on and off
• Pressing the ON/OFF (7) switch will activate the power tool.
• Releasing the ON/OFF (7) switch will stop the power tool.
Display with control panel
• Press to turn on the display
• Press to change unit (bar/PSI)
• Press and hold to enable pressure setting
• Keep pressing to increase pressure
• Press and hold to enable pressure setting
• Keep pressing to decrease pressure
Pumping up
1. Connect the adapter suitable for the object to be pumped up to the clip-on tire valve.
2. Connect the adapter to the valve stem of the object to be inflated.
3. The display turns on automatically and shows current pressure of the object.*
* Only for the car/bicycle tires. Pressure in objects such as sport balls is too low for the
air pump to detect it.
4. Pumping up can be carried out in two ways:
• Manually- by pressing and holding the ON/OFF switch until desired pressure is
reached, then release the ON/OFF switch.
• Automatically- first set the desired pressure with the +/- buttons. Wait until the values
stop flashing and then press and hold the ON/OFF switch. The air pump will stop
automatically when the preset pressure is reached. Release the ON/OFF switch.
5. Increase in pressure is being shown on the display.
6. Disconnect the air pump from the object.
7. Remove the adapter from the clip-on tire valve (if it has been used) and put it back in
the accessory compartment.
Tips:
• When pumping up objects of 0,7 bar or less, pump up in short bursts and check after
each burst by feel or with a calibrated measuring device to determine accurate pressure.
Using the power tool for an extended period of time may lead to damage to the object
being pumped up.
• Secure the object if necessary.
MAINTENANCE
Before cleaning and maintenance, always switch off the power tool and remove the
battery.
37 EN