Rebel RB-1099 Manual Del Usuario página 25

6. Do not use the power tool if the switch does not turn it on and off. any power tool
that cannot be controlled with the switch is dangerous and must be repaired.
7. Disconnect the plug from the power source and/or the battery pack from the power
tool before making any adjustments, changing accessories, or storing power tools.
such preventive safety measures reduce the risk of starting the power tool accidentally.
8. This power tool may be used by children who are above 8 years old and by persons with
reduced physical, sensory or mental capabilities, or lack of experience and knowledge,
if they are supervised and guided by a person who is responsible for their safety in a
cautious manner for all the safety precautions being understood and followed.
9. Store idle power tools out of the reach of children and do not allow persons unfamiliar
with the power tool or these instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
10. maintain power tools. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tool's operation. If
damaged, have the power tool repaired before use. Many accidents are caused by
poorly maintained power tools.
11. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
12. Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. use of the power tool for operations different from those intended could
result in a hazardous situation.
Service
1. Have your power tool serviced by a qualified repair person using only identical
replacement parts. this will ensure that the safety of the power tool is maintained.
additional safety warnings for hot air guns
• Improper or careless use of the power tool increases risk of fire.
• Secure the workpiece. Never hold the workpiece in your hand or across your legs
or against your body. a workpiece clamped with clamping devices or in a vice is held
more secure than by hand. an unstable workpiece can cause loss of control of the tool
and/or injury.
• Do not cover ventilation slots with your hands or other parts of your body.
• Hold the power tool by the grip with one hand.
• Do not block or cover air inlet/outlet as accumulated hot air may damage the
power tool.
• Ensure proper ventilation and provide for fresh air to the work area.It is not
recommended to use the power tool in the vicinity of explosive or inflammable
materials; if it is unavoidable please exercise extra caution when working in such
environment.
• Do not keep the power tool directed at one spot too long.
• The nozzles achieve high temperature during use. Do not touch them! Let them cool
down completely before attempting to remove them from the air outlet. always wear
protective gloves to prevent burning.
25 EN