Toparc Kit NUM-1 Manual De Instrucciones página 6

INSTALLATION
WARNING
ELECTRIC SHOCKS CAN BE FATAL
Only experienced personnel authorised by the manufacturer may carry out the installation. During installation, make sure
that the generator is disconnected from the mains.
Video for the kit's installation:
https://www.youtube.com/playlist?list=PL7Y7wApgIJaSwDJ9f3_4KyWe84UZrinBp
(Remote control)
https://www.youtube.com/playlist?list=PL
7Y7wApgIJaTDVIgFrVxc1ZOBzCnXfehe
Any access to internal areas beyond the areas described in this video guide is prohibited and voids the warranty and any other form of support.
Indeed, these manipulations may be damaging to the parts and/or the internal electronic components of the generator.
HARDWARE ERROR
If the following error appears in the display, the «Slave» configura-
tion of the NEOFEED/PULSFEED wire feeder was not followed.
The configuration is visible in the video (see above).
ON ON ON
Master
1 2 1 2 1 2
SCREEN DISPLAY
Wire Feeder N°1 = Master
6
NUM-1
NUM-1
or
ON
Slave
1 2
Wire Feeder N°2 = Slave
KIT NUM-1
NUM-1
https://www.youtube.com/playlist?list=PL
7Y7wApgIJaTDVIgFrVxc1ZOBzCnXfehe
HARDWARE Error
The functionalities of the «Slave» wire feeder are
limited.
(External wire feeder)
For use with double wire
feeders, the external wire fee-
der must be configured as a
«Slave» wire feeder. To confi-
gure it, follow the instructions
in the following video:
1 2
NODE : MMI 2
CODE : 0000
BAD BANK ID for MMI-5
EN