Epson Ni-MH Manual Del Usuario página 6

For US and Canadian users
Use the included power cord or a 6 to 10 feet long UL-
approved type NISPT-2, 2 x 18 AWG cord with a 125 V 10 A
polarized plug and 125V 7A connector.
The Ni-MH Battery Charger is equipped with a polarized
alternating-current line plug (a plug having one blade wider
than the other) and polarized power inlet. These plugs only
fit into a power outlet and your equipment in one way. This
is a safety feature. If you are unable to insert the plug
properly, try reversing the plug. If the plug still fails to fit,
contact an electrician to replace your outlet. Be sure to use
only the polarized AC cord that comes with the Power Pack.
If you plan to use the camera and options in Germany,
observe the following:
To provide adequate short-circuit protection and over-
current protection for these products, the building
installation must be protected by a 16 Amp circuit
breaker.
Bei Anschluß des Produkts an die Stromversorgung
muß sichergestellt werden, daß die Gebädeinstallation
mit einem 16 A-Überstromschalter abgesichert ist.
For the batteries
Use only the EPSON Ni-MH Battery Charger, Model EU-38,
to charge these batteries.
Do not apply heat or force to batteries, and do not
disassemble, drop, short circuit, or put batteries into fire or
water.
Do not insert batteries into wall outlets or other power
sources such as a car cigarette lighter socket.
Do not solder lead wires or terminals directly to a battery.
The batteries should only be used with EPSON Digital
Cameras as specified in your camera's User's Guide.
4