Vacuuming Dry Materials; Vacuuming Liquids; Important; Emptying The Drum - RIDGID 1400RV0 Manual Del Usuario

SP6939-1 16 GALLON ESF1_SP6939-1 1/16/15 9:39 AM Page 10
Find Quality Products Online at:
Operation (continued)

Vacuuming Dry Materials

1. The filter must always be in correct
position to reduce the risk of leaks and
possible damage to Vac.
2. Your Wet/Dry Vac comes with the
VF5000 Filter installed. When using
your Vac to pick up very fine dust, it will
be necessary for you to empty the
drum and clean the filter at more
frequent intervals to maintain peak Vac
performance.
NOTE: A dry filter is necessary to pick up
dry material. If you use your Vac to pick
up dust when the filter is wet, the filter will
clog quickly and be very difficult to clean.
Allow filter to dry out before storing.

Vacuuming Liquids

IMPORTANT:

1. When picking up small amounts of
liquid the filter may be left in place.
2. When picking up large amounts of
liquid we recommend that the filter be
removed. If the filter is not removed, it
will become saturated and misting may
appear in the exhaust.
3. After using the Vac to pick up liquids, the
filter must be dried to reduce the risk of
possible mildew and damage to the filter.
4. When the liquid in the drum reaches a
predetermined level, the float
mechanism will rise automatically to cut
off air-flow. When this happens, turn off
the Vac, unplug the power cord, and
empty the drum. You will know that the
float has risen because Vac airflow
ceases and the motor noise will become
higher in pitch, due to increased motor
speed.
GlobalTestSupply
www.
IMPORTANT: To reduce the risk of
damage to the Vac do not run motor with
float in raised position.
!
WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.

Emptying the Drum

!
WARNING: To reduce the risk of
back injury or falls, do not lift a Vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the Vac light enough to lift
comfortably.
1. The Vac comes equipped with a drain
for easy emptying of liquids. Simply
unscrew the drain cap and lift the
opposite side slightly to empty the
drum.
2. Another option is to remove the
powerhead assembly.
3. Lay powerhead assembly aside on
a clean area while emptying drum.
4. Dump the drum contents into the
proper waste disposal container.

Moving the Wet/Dry Vac

Should it become necessary to pick
the Vac up to move it, the handle on
the sides of the dust drum are used to
lift. To maneuver the Vac, the push/pull
handle in the rear of the unit should be
used.
10
.com
sales@GlobalTestSupply.com