GE HTS18CCSRWW Manual Del Propietário página 14

2
REVERSING THE DOOR SWING
REVERSING THE DOOR HANDLES
5
5.4 Transfer Freezer Door Handle
5.4.1 Remove the screw
holding the handle
to the top of the
door and the two
screws holding the
handle to the bottom
of the door.
5.4.2 Remove the handle.
5.4.3 Remove the screw from the
right top edge of the door
and insert it into the
handle screw hole on the
left side.
5.4.4 Transfer the door stop as shown in preceding
section 5.2.
5.4.5 Attach the handle to the
right edge of the door
with screws at top and
bottom, using bottom holes
vacated by removal of the
door stop screws.
RE-HANGING THE DOORS
6
6.1 Re-hang the fresh food door
6.1.1 Lower the fresh food door onto the
bottom hinge pin. Be sure the washer
is in place on the pin.
Hinge
Bracket
Installation Instructions
(CONT.)
Top
TOP
Bottom
BOTTOM
Plastic
Washer
14
(CONT.)
RE-HANGING THE DOORS
6
6.1.2 Insert the pin on the center hinge into the socket in
the top of the door. Place the spacer, then the
washer, on the hinge pin.
NOTE: The center hinge must
be turned over as shown when
mounted on the left side.
6.1.3 Tilt the door toward the cabinet. As the door is
brought into position, slide the hinge under the head
of the screw which earlier had been partly driven into
the outermost hole. Insert the remaining screw, then
tighten both screws securely.
6.2 Re-hang the freezer door
6.2.1 Lower the freezer door
onto the center hinge
pin. Be sure the
washer and spacer
are in place on the pin.
6.2.2 Tilt the door toward the cabinet, lifting the top hinge
so the pin fits into the socket on the top of the door.
6.2.3. Make sure the door is slightly above the top of the
cabinet and the gap between the doors is even across
the front. Tighten the top hinge screws. Do not
overtighten these screws–tighten them until they are
just snug, then turn them another one-half turn.
(CONT.)
Hinge Pin
Plastic Washer
and Spacer
Center Hinge Pin
Plastic Washer
and Spacer