Berner RS25e Manual De Instrucciones página 8

MAGNETIC-STAND DRILLING MACHINE RS5e
GB
10. Do not use the cable for other purposes.
Do not use the cable for carrying the tool and do not
use it to pull the plug out of the socket.
Protect the cable from heat, oil and cutting edges.
11. Secure your workpiece.
Use a fastening device or a vise to fix the workpiece.
The workpiece is better fixed than by hand and it
makes it possible to use the tool with both hands.
12. Do not lean too far over the machine.
Take care to keep a normal position.
You should have a secure standing position and you
should keep your balance.
13. Maintain your tools carefully.
Keep your tools sharp and clean - working with them
will be better and safer. Follow the maintenance ins-
tructions and indications concerning the replacement
of tools.
Check the cable regularly and in case of damage let
it replace by an expert.
Also check extension cables regularly and replace
them if they are damaged.
Keep handles dry and free from oil and grease.
14. Pull the plug out of the socket.
If you do not use the machine, before maintenance,
while changing tools like saw blades, drills or any
kind of machine tools.
15. Remove tool keys.
Before turning the machine on, make sure that all
keys and adjustment tools are removed.
16. Avoid turning on the machine inadvertently.
Do not carry tools that are plugged in with your finger
on the switch. Make sure the switch is on „off" positi-
on while plugging in the tool.
17. Extension cables outdoors.
Only use extension cables that are authorized to be
used outdoors and that are accordingly marked.
18. Always take care.
Control your work. Be sensible and do not use the
tools when you have difficulties in concentrating.
19. Check if your appliance shows damages.
Before further use of the tool please check if safety
appliances or damaged parts are working correctly.
Check if the moving parts function correctly, if they
move without problems, if no parts are broken, if all
other parts are fixed correctly and if all other condi-
tions that influence the working of the machine are
fulfilled.
If the use instruction does not say otherwise the da-
maged safety appliances and parts should be either
repaired or replaced correctly.
Damaged switches have to be replaced.
Do not use tools where the switches cannot be set to
„on" or „ off".
20. Attention!
For your own safety only use accessories and a
attachments that are indicated in the use instruction
or are offered in the according catalogue.
The use of tools or accessories other than recom-
mended by the use instruction may be dangerous.
21. Repairs should be carried out only by experts.
Electric tools are subject to the according safety
regulations. Repairs may only be carried out by an
expert, otherwise the user runs the risk of accidents.
Please keep these instructions carefully.