Kalorik USK KS 2 Manual De Instrucciones página 5

FIXING THE WALL-MOUNTING BRACKET
Select a point in the vicinity of a wall socket, indoors and not
•
subject to damp.
Put the bracket against the wall considering that the appliance
•
should be placed with the handle facing upwards.
Take a pencil and mark a dot in each hole situated at the back
•
of the bracket.
Take the bracket off the wall and drill a hole on each dot you just
•
marked.
Put a plug in the holes and tighten the screws in the holes, letting
•
them more or less 4 millimeters out of the wall.
Before fixing the bracket onto the wall, pass the power cord in
•
one of the notches foreseen, making sure that the cord is long
enough to reach the power socket.
Fix the bracket by putting the screws into the widest part of the
•
holes situated at the back of the bracket and slide the bracket
downwards.
CHARGING THE VACUUM CLEANER
Please read, follow and keep this instruction manual. Before using
your vacuum cleaner for the first time, charge the accumulator
during approximately 16 hours. A fully charged accumulator will give
approximately 10 to 12 minutes vacuum cleaning.
The adaptor should only be connected to a 120V, 60Hz power
supply.
Important: The charger and its cord cannot be repaired. Should they
be damaged, they must be thrown out. Contact the customer
service to replace them. Put the plug into a 120V wall socket and put
the vacuum cleaner onto the wall-mounting bracket with its handle
upwards. The charging indicator will come on, indicating that the
vacuum cleaner is positioned correctly on the bracket and that the
charging process will start. The charging indicator will stay illuminated
even if the battery is fully charged.
You can leave your appliance on the bracket indefinitely, although
we suggest un-plugging it or disconnecting the power supply if it is
not used for more than one week. The batteries need to be drained
of power and recharged periodically to maintain their performance.
5
USK KS 2 - 060104