Do not charge the battery if the room temperature falls below 0°C or
rises to more than 37°C.
The charger will warm up during use. This is perfectly normal.
USE
Once your appliance is charged, remove it from the bracket by
holding it by its handle. Switch it on by pressing the ON/OFF switch.
Tilt the vacuum cleaner till the nozzle of the dust collector is placed
horizontally compared to the surface that is to be cleaned. When
you are finished, release the ON/OFF switch and the appliance will
be switched off.
To clean surfaces that are difficult to reach, use one of the crevice
tools. Caution: the large crevice tool cannot be attached directly to
the appliance, but must first be fitted to the small crevice tool, that
can then be attached to the appliance. To clean flat damp
surfaces, use the squeegee. With this accessory you can scrape the
liquid to vacuum it easily. After having vacuumed liquids or humid
particles, clean the dust collector to avoid smells.
MAINTENANCE
Cleaning the filter and the dust collector is extremely important as
•
it allows the optimal use of your appliance and eliminates the
unpleasantness due to bad smells that can occur after having
vacuumed liquids or humid particles.
Remove the dust collector by
•
pressing the release button situated
on top of the appliance (see picture
A). We advise you to do this over a
dustbin.
Remove the filter. To do so, turn the
•
filter holder anti-clockwise to release it
from the dust collector and take it out
(see picture B).
A
B
6
USK KS 2 - 060104