Installing The Spray Bar; Installing Chassis And Suspension (Wr 50) - Kärcher WR 20 Manual De Instrucciones

1 Trigger gun
2 Flow restrictor
3 Spray lance
 Install flow restrictor between trigger
gun and spray lance.
 Check that the screw connections are
leak-tight after installation.
Spray bar

Installing the spray bar

 Screw the spray bars onto the spray
lance.
 Tighten the screw connection with a
wrench.
10
Note
The openings of the spray bar must face
downwards not forwards.
Installing chassis and Suspension
Note
If necessary, the WR 50 can be used with
the chassis and suspension.
 Insert spray bar into the chassis and
suspension support.
Note
On the support, adjust the clearance be-
tween the spray bar and the surface (ap-
prox. 50 mm - 100 mm above the surface).
 Loosen the star handle screw.
 Move the spray bar in the holder.
 Tighten star handle screw.
– 3
EN
(WR 50)