Using The Touch Screen - Remington Touch Control MB4560 Manual Del Usuario

ENGLISH
, CAUTION
• Extended mains only use will result in the reduction of the battery life.
, WARNING
• The appliance can not be operated in corded mode while connected to a PC
via the USB port.
, CORDLESS USE
• When the unit is switched on and fully charged, the product can be used in
cordless mode for 50 minutes.
F INSTRUCTIONS FOR USE
• Always comb your beard or moustache with a fine comb before you start
trimming.
• Turn the product on by sliding the 3 position slide switch down to the
middle position. This will turn the LCD display on and enable height
adjustments and boost adjustments to be made.
• Your trimmer can be adjusted in either 0.1mm or 0.5mm increments. To
switch between these, press and hold the mode button for 3 seconds. The
increment that the trimmer is now set at will be displayed (or flash) for 1
second.

, USING THE TOUCH SCREEN

• The trimmer comb can be adjusted to give you 175 different trim lengths,
with 0.1mm increments, simply by pressing the arrows on the touch
screen. Press and hold the arrow up to increase the cutting length and down
to decrease it. The setting number will appear on the digital display.
• Select the desired boost level by pressing the boost button with the 3
position slide switch in the middle position. The display will indicate the
level.
• Once the desired length and boost level have been selected slide the 3
position slide switch to the last position (the furthest down) to lock the
cutting length and turn the motor on.
• Note: Adjustments to length and boost can be done anytime the 3 position
slide switch is set to the middle position. Adjust the cutting length and or
boost level by pressing the arrows or boost button on the touch screen.
• Please note that the motor will only run when the 3 position slide switch is
set to lock, the last position (furthest down). This is to ensure the cutting
length does not adjust whilst you are cutting your hair.
• Note: Trimmer comb must be attached to the groomer in order to use the
hair length selector. To achieve 0.4mm, the comb must be removed.
5