Troubleshooting; Tv Troubleshooting; Dvd Player Troubleshooting - Insignia NS-15CLTV Guia Del Usuario

NS-15CLTV - combined.fm Page 20 Wednesday, July 26, 2006 1:01 PM

Troubleshooting

TV troubleshooting

Please check the following items before asking
for repair service:
Problem Solution
No picture or Check all cable connections.
sound.
Make sure that the TV is turned on.
Picture is OK, but Check the volume level and mute settings.
no sound.
Sound is OK, but no Check the color control and adjust it.
color.
Check the program's color features, because it
may be a black and white movie.
The picture has Make sure that the antenna is installed
overlapped images. correctly. If not, adjust the antenna toward the
broadcasting station.
Picture has "snow." Check the antenna and its connection. If there
are problems, correct them. If all connections
are tight, the problem may be with a faulty
antenna or cable.
Check whether car traffic or neon signs
disturb the image.
Stripes on picture. Check for interference from other electronic
devices, such as radios and televisions, and
keep magnetic or electronic devices away
from the TV.
Bad stereo or SAP Long distance from the station or interfering
sound. radio waves can generate bad sound
reception. If so, change the mode to Mono.
Remote control Change the batteries in the remote control.
does not work.
Remove any obstacles between the TV's IR
sensor and the remote control.
"Out Of Range" Check the resolution and frequency of your
appears on the computer, and adjust it to the optimum
screen. resolution for this TV: 1024 × 768 and 60 Hz.
"No Signal" appears Make sure that the cable is firmly connected to
on the screen. the computer and TV.
Image is not clear. Adjust the PHASE control.
Image is not Adjust the Horizontal control.
centered.
20
Insignia NS-15CLTV 15" Combo DVD/LCD TV

DVD player troubleshooting

Problem
No sound
No image
Bad sound quality Make sure that the audio output mode is set
Disc cannot be
played
The player doesn't
operate normally
Remote control
does not work
www.insignia-products.com
Solution
Make sure that the TV or amplifier is working
properly.
Make sure that the amplifier is set to receive
DVD signal output.
Make sure that the TV is working properly.
Make sure the color system is set correctly.
correctly.
Make sure that the audio connection between
the unit and amplifier (if used) is secure.
Make sure the disc is inserted with the label
facing forward.
Clean the disc.
Moisture has condensed in the player. Remove
the disc and leave the player on for about an
hour.
This player can only play 12cm discs.
Disconnect the power plug, then reconnect it.
Remove obstacles between the remote control
and the player.
Point the remote control at the TV's IR sensor.
Install fresh batteries.