Hanwha Techwin SBP-300NB Manual Del Usuario página 23

5. Place the housing on the install bracket as shown in the image.
To install it on the wall, attach the rubber housing as shown in the figure.
`
The rubber is not waterproof. It is decorative only, serving to hide a gap.
Therefore, if the cable is inserted into the main body separately and not through the duct on the wall, the insertion
point of the cable must be completely waterproof.
If this is not done, any water leaks may cause problems.
6. Secure the housing to the install bracket using 4 M8 screws in the same ways as "No. 4" in the
installation procedure.
Waterproofing
needed
Cable
English _9