Publicidad
support@nextlevelracing.com
Line up pre-drilled holes on the 40x40 extrusion with the holes on the bracket previously installed in
04
step 03B, bolt through and secure with a nut.
05
Slide 2 x T-nut into the bottom channel of the extrusion
PARTS:
1 X 40X40 EXTRUSION
2 X M8 WASHER
2 X 65MM M8 BOLT
2 X M8 NUT
TIPS:
The aluminium extrusion has 2
pre-drilled holes
06
PARTS:
2 X T-NUT
07
Line the holes on the connector bracket with the pre-drilled holes in the 40x40 extrusion then bolt
through the bracket and holes with 2x M8 65mm bolts, washers and the nuts.
Line up holes on the Keyboard connector bracket with the holes on the connector bracket previously installed in
Step 06 and install a barrel spacer between the holes. Bolt through the lined up holes and secure with a nut
Video Instruction: bit.ly/nlrbuild
PARTS:
1 X CONNECTOR BRACKET
2 X M8 NUT
2 X M8 WASHER
2 X 65MM M8 BOLT
TIPS:
Line connector bracket up with
holes in 40x40
PARTS:
1 X KEYBOARD CONNECTOR BRACKET
1 X 65MM M8 BOLT
1 X M8 WASHER
1 X M8 NUT
1 X 35MM M8 BARREL SPACER
Publicidad
