General Maintenance - Husky C301H Guía De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation (continued)
4
How to start (Figure 2)
1.
Turn the Auto/Off switch (A, Figure 2))
to "Auto" and allow tank pressure
to build. Motor will stop when tank
pressure reaches "cut-out" pressure.
2.
When the tank pressure reaches "cut-
out" pressure open the air discharge
valve.
WARNING: Risk of bursting. If
any unusual noise or vibration
is noticed, stop the air
compressor immediately and
have it checked by a trained
service technician.
NOTICE: When using regulator
and other accessories refer to the
manufacturers instructions.
Maintenance

GENERAL MAINTENANCE

Condensate forms in the tank when
there is humidity in the air. Depending
on the environmental conditions, drain
the condensate daily and/or every hour.
For instructions, see Draining the tank
paragragh under Operation.
The safety valve automatically releases air
when the receiver pressure exceeds the
preset maximum.
Inspect the tank annually for rust, pin holes,
or other imperfections that could cause it to
become unsafe.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil,
grease, etc.
WARNING: Do not allow brake
uids, gasoline, petroleum based
products, etc., to come in contact
with plastic parts. Chemicals can
weaken or destroy plastic which,
may result in serious personal
injury.
WARNING: When servicing, use
only identical Husky replacement
parts. Use of any other parts may
create a hazard or cause product
damage.
WARNING: Always disconnect
the air compressor from the
power supply, release all
pressure, and allow it to cool
before cleaning or making repairs
on the air compressor.
12

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

723883

Tabla de contenido