Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3: Hose installation
Connect the intake and outlet tubes (1.37/1.38) to the hoses included with
the kit. Avoid hoses being bent sharply or loops being formed. Shorten
the hoses – if the full length is not required – according to your installation
requirements. The shorter the hoses, the less friction loss there is. Should
you need longer hoses, however, please choose the corresponding di-
ameter [16/22 mm (0.63/0.87 in.) for the UVC-Xtreme 800, and 18/23 mm
(0.71/0.91 in.) for the UVC-Xtreme 1200]. Smaller internal hose diameters
i reduce the o rate
ou insta hard inta e and out et tu in via a
hose connector, please choose an appropriate diameter and make sure
ou use
e o fittin s and not
Connect the hose from the intake tube coming from the aquarium to the
va ve and the hose to the out et tu e ac into the aquarium ith the
va ve
se the union nuts or on the va ves or securin the hoses
First loosen the nuts and push them loosely over the hose (7.4).
Then please push the hose ends into the circular gap between the pres-
sure latches and the inner edge of the hose connector. Then fasten the
squeezing screws of the valves by hand (please do not use any unsuitable
too s such as a i e rench
to each other
hen ou can connect the va ves to the fi ter head
valve nozzles (7.6).
Mount the spray bar by means of the included suction cup holders un-
derneath the desired water surface of the aquarium and direct it in a way
that the small holes are roughly parallel 5 – 15 cm (2 – 6 in.) underneath
the water surface (7.1).
onnect the
inta e va ve to the connector on to o the fi ter head
mar ed in the same a and ana o ous the
connector
Step 4: Start
i the canister ith ater
to the canister appropriately. The UV-C tube (1.20) must be inserted
into the ho es o the fi ter media as ets
connected to the fi ter canister
ease ma e sure the fi ter head sea is seated ro er
ta s on the
and
va ves
et
o connect the inc uded a ast to the mains soc et and connect
an ed arre
u to the soc et on the fi ter head
he motor o the fi ter
i no
i sho
active
s
o
and thus activate the suction um
tra
ed inside the fi ter into the
after 15 seconds, then the motor will start. Water will now run from the
aquarium into the fi ter
he suction um can e activated re eated
as required in case there is sti air tra
tional noise will be louder as long as air still gets to the rotor, but this will
disappear after a few minutes. This time can even be shortened if you
set the motor performance to level 8 for a short while.
Step 5 Adjusting the ow rate choosing the performance setting
You can adjust the motor performance as required after the air has been
removed com ete
rom the fi ter
ressin the
e on the contro
ormance settin o the motor
it by one step each time you press it.
The default setting is level 4. This setting will be active every time the
fi ter has een disconnected rom the mains su
to re-adjust it if applicable.
During operation, you can at any time re-adjust the motor performance
o the fi ter um
e ce tion not hi e the suction um is active
Technical data
U C treme 8
Level
Filter circulation*
(l/h / US gph)
1
450 / 119
2
590 / 156
3
630 / 166
4
650 / 172
5
685 / 181
6
740 / 196
7
770 / 203
8
840 / 222
UV-C lamp
an e ieces
o hoses and ta s are firm connected
out et va ve to the
a out t o thirds and attach the fi ter head
he fi ter head is no
c osin the
c i
oc s
i ou have not a read done so
start runnin on eve
the dis a
ress the S
e on the contro
o the suction um
hose
he suction um
ed inside the fi ter
ane
once increases the er
one ste
ressin the
ou i then need
Pump power consumption (W)
5
8.5
10
11.5
13
15
17
19
additionally 5
U C treme 12
Level
1
2
3
4
5
6
7
8
UV-C lamp
ircu ation measured ith fi ter head mounted on fi ter canister
ith fi ter media as ets ithout fi ter materia
Technical data
sera U C treme 8
(order code 32147)
terna i ter or
(26 – 211 US gal.)
fresh water aquariums
24 V
ma
incl. UV Lamp 5 W G23
ma
S
sera ballast (order code 32181)
n ut
The UV-C amalgam lamp switches on together with the motor and can
e s itched o
and
tank, the lower the required hourly water turnover in the aquarium. The
lower the circulation setting, the higher the degree of the pathogen and
o o en the
a ae reduction since the ater assin the
to the UV-C radiation longer. Depending on the pathogenic pollution it
ma
e advanta eous to choose a re ative
and then accelerate it by and by. Certain pathogens can divide every
20 minutes and therefore multiply immensely within shortest time. Once
most of the pathogens have been eliminated with a low motor performance
ane
setting, you can increase the motor performance as required. This is of
i
ress air
course only a pathogen reduction, not a sterilization. Sterile conditions are
i sto
impossible in an aquarium with animals, plants, decoration and sand. The
use u fi ter acteria are ocated on the fi ter media and on sur aces he
are not a ected
he o era-
Switching the U C lamp on and off
he
am is s itched on automatica
o eration his is indicated
recommend ermanent
1 Switching off the U C lamp
e reduces
During maintenance, the UV-C lamp can be switched off easily by
ressin the
light up once while the blue LED indicator in the center that indicates
UV-C operation will turn off.
2 Switching on the U C lamp
ress the
will light up twice when doing so while the blue LED in the center that
indicates UV-C operation will turn on.
Separating the external filter from the mains supply
he e terna fi ter can e s itched o
– pulling the barrel plug from the socket (6.5); or by
– pulling the mains plug of the ballast from the mains socket.
pening of the filter head
irst s itch o the e terna fi ter
c ose the
eave the fi ter head in osition other ise
valves underneath the valve taps (7.6). A small amount of water can run
out of the valve when doing so.
16
Filter circulation*
(l/h / US gph)
570 / 150
730 / 193
820 / 217
920 / 243
980 / 259
1040 / 275
1090 / 288
1220 / 322
sera U C treme 12
(order code 32148)
terna i ter or
(53 – 317 US gal.)
fresh water aquariums
incl. UV Lamp 5 W G23
h ma
ma
h ma
50/60 Hz / Output 24 V DC 2A
ressin the e
the
radiation o the
the ue
ater treatment hi e the fi ter is in o eration
e
hen doin so the
e on the ane
rie
u in the arre
ta s
en the
Pump power consumption (W)
5
9
12
15
18
20
23
29
additionally 5
m
t inc uded hose attached
ma
h ma
S
h ma
i desired
he sma er the
unit is ein e
osed
o
ater turnover at first
treme fi ter
hen uttin the fi ter into
i ht on the fi ter head
e
th
LED indicator (red) will
he
th
LED indicator (red)
u
hen
ho der c i s
ut
o
ou can unscre
the
Publicidad
