Kicker 19417163 Manual Del Usuario página 4

Install the amplifier onto the amplifier bracket with the supplied screws (short screws x 4). Fig 6
Connect the amplifier harness to the amplifier and the four-pin connector to the tilt switch attached to the
amplifier bracket. Fig. 7 Route the harness along the factory harness toward the passenger side.
Note: The tilt switch is designed to turn the speaker system off when the inner
tailgate is not in the fully down position. Failure to make this connection or
attempting to bypass this switch will result in a constant drain on the vehicle
battery. Likewise, any cutting, splicing or any other modifications made to the
amplifier harness will immediately void the warranty.
Disconnect the connector pictured and install the light kit T-harness (if equipped). Fig 7
Fold the inner tailgate section down and snap loose the plastic hinge cover on the passenger side to aid in
harness routing. Fig 8
Disconnect the negative battery cable.
Continue to route the amplifier harness along the factory harness to the underneath side of the bed near
the back side of the trailer connector. Secure amplifier harness to factory harness with supplied wire ties.
Fig 9
Note: Trim wire tie ends.
Tilt Switch
Fig 6
Fig 8
Light Kit
Connection
Fig 7
Fig 9
4