Braun Silk epil EverSoft 2390 Manual De Instrucciones página 14

7. Give the top of the housing a quick
clean with the brush. Put back on
the epilator head and the EverSoft
attachment.
B Shaving
1. Take off the protective cap
Put on the shaver head
clicking it in (the long hair trimmer
should be in front).
2. When using the shaver head,
always slide switch
setting «2».
3. For best results, guide the shaving
system so that about half of the
shaving foil and the trimmer are
in contact with your skin.
Always guide the appliance in
the direction of the trimmer.
The trimmer first raises all long
hairs and cuts them off. Then the
flexible foil follows to smooth
away any stubble.
Cleaning the shaver head
4. After shaving, unplug the
appliance. The shaver head is
a precision part that should be
handled with care. In order to
clean the shaver head, remove
the shaving foil frame
so, press the release bars
the front and back and pull it off.
5. Carefully tap the shaving foil frame
on a flat surface.
14
.
8a
by
8
up to
4
. To do
8b
on
8c
6. Brush out the cutter block
well as the area below the cutter
block.
7. Also brush the inner area of the
shaving foil frame.
N.B.: The shaving foil is a very
delicate part that must not be
cleaned with the brush.
8. We recommend that you oil the
trimmer every 3 months with
a drop of sewing machine oil.
9. Put the shaving foil frame back
on and snap it into place.
Put on the protective cap
Note: Do not use the shaver head
with a damaged shaving foil.
Replacing the shaving parts
The shaving foil and the cutter block
are precision parts that wear out with
the time. Have the shaving foil frame
and the cutter block
8b
when you notice a reduced shaving
performance.
Subject to change without notice.
This product conforms to the
EMC-Requirements as laid
down by the Council Directive
89/336/EEC and to the Low
Voltage Regulation (73/23 EEC).
as
8d
.
8a
replaced
8d