doing!
use the quick coupling adaptor.
Never use the air impact wrench near
ignite the dust or fumes.
free from grease or oil.
working pressure.
Never run the tool unloaded with full speed!
2 bar up
to max. 7 bar. When using higher pressure, life
Before exchanging the tool (socket etc.) or doing
air impact wrench from the air source.
do not use!
for the air impact wrench.
hold balance. Avoid abnormal posture.
cause accidents!
Never open the air impact wrench and never
OPERATION
Installing and exchanging tools
As the air impact wrench is equipped with a ½''
start-up.
accessories that are constructed for the air
impact wrench.
working.
Start-Up
1. The air impact wrench is provided with a ¼'' air
air impact wrench and the air hose, but use the
supplied quick coupling adaptor (7) instead.
www.Deuba24online.de
2.
3.
through the opening of the compressed air
mini oil-fog lubricator (8). Also take a look at
4. The quick coupler of the air impact wrench
now has to be connected with the compressor.
Switch the compressor and setup a pressure of
6.2 bar.
5. To start the tool, press the trigger (2). The
trigger also is used to control the speed of
faster it will run. When working, hold the tool
6.
backside of the unit.
clockwise
7.
turn it to the desired stage.
Lowest stage: maximum torque 140 Nm
Highest stage: maximum torque 340 Nm
8.
when exchanging the socket/tool and when
from the air impact wrench.
10
11
www.Deuba24o nline. de
Tips for use
Use the air impact wrench for screwing on as
well as unscrewing of nuts and bolts. It creates
40
and screws.
Care and Maintenance
required. Dust, dirt or corrosion residues from
of the tool and will cause technical problems.
equipment removes moisture and dirt from the
air, controls the working pressure and supplies
that include abrasive or aggressive chemicals as
parts.
Make sure liquids do not enter the tool and
never put it into liquids. The compressed air
drain and clean the air lines, compressor and air
recommended to use an oil-fog lubricator. If the