Tabla de contenido
Publicidad
I
NSTALLATION
Truck Requirements
WARNING: Rated capacity of the truck/
attachment combination is a responsibility
of the original truck manufacturer and may
be less than that shown on the attachment
nameplate. Consult the truck nameplate.
Truck Relief Setting
160 bar Recommended
200 bar Maximum
Truck Flow Volume
60A
➀ Cascade 60A Fork Positioners are compatible with SAE 10W
petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-5606 or
MIL-0-2104B. Use of synthetic or aqueous base hydraulic fluid
is not recommended. If fire resistant hydraulic fluid is required,
special seals must be used. Contact Cascade.
➁ Flow less than recommended will result in reduced or unequal
fork speed.
➂ Flow greater than maximum can result in excessive heating,
reduced system performance and short hydraulic system life.
Carriage Mount Dimension (A) ITA (ISO)
A
Class IV
GA0028.eps
Auxiliary Valve Functions
Check for compliance with ITA (ISO) standards:
6536947 EN
➀
Min.
➁
Recommended
15 LPM
26 LPM
Minimum
595.5 mm
GA0082.eps
Max.
➂
26 LPM
Maximum
597.0 mm
Tilt Forward
Sideshift Left
Hoist Down
Hoist Up
Tilt Back
Sideshift Right
Carriage – Clean and inspect carriage
bars. Bars must be parallel and ends
flush. Grind smooth any protruding welds
that may affect roller bearings. Repair
any damaged notches.
Open Forks
Close Forks
GA0080.eps
5
Publicidad
Tabla de contenido
