Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION OF SHELF
NOTE: Lower shelf does not require hardware to
assemble.
NOTE: Install shelf only after table has been
fully assembled and all bolts and nuts are
tightened.
Figure 8
HARDWARE INCLUDED
• (2) M6 x 12 mm Phillips Head Bolts
• (2) M6 Hex Nuts
• (2) M6 Flat Washers
NOTE: Install add-on shelf only after starter
table, add-on table and starter table shelf
have been fully assembled and all bolts and
nuts are tightened.
Figure 9
Cross Bar
PAGE 3 OF 9

SHELF INSTRUCTIONS

1.
ADD-ON SHELF ASSEMBLY
1.
2. Fasten add-on shelf to starter table shelf with two
1-800-295-5510
uline.com
Position lower shelf underneath table and line up
with lower cross bar of each leg set. Place shelf over
cross bars. (See Figure 8)
Position add-on shelf underneath add-on table.
Align flat end of add-on shelf with holes over holes
located on starter table shelf. The add-on shelf will
overlap the starter shelf. Place other end of add-on
shelf over add-on table cross bar. (See Figure 9)
M6 x 12 mm Phillips head bolts, M6 hex nuts and
M6 flat washers using a 10 mm wrench and Phillips
screwdriver. (See Figure 9)
1021 IH-5785

Publicidad

Tabla de contenido
loading

Tabla de contenido