Hardware Included - Uline H-5785 Guia De Inicio Rapido

Figure 6
Starter
Table

HARDWARE INCLUDED

• (2) 3/8 x 3/4" Bolts
• (2) 3/8 x 1" Bolts
• (2) 3/8 x 3" Bolts
• (2) Caster leg inserts
• (6) 3/8" Flange nuts
• (2) Long braces
ASSEMBLY OF ADD-ON TABLES
1. Repeat steps on page 1 for leg assembly.
NOTE: Be sure to adjust legs to same
height as the starter table.
2. With the aid of a helper, align add-on table to
starter table. The holes on the underside of both
table tops should line up. Install (2) 3/8 x 3/4" bolts
and nuts through holes provided. (See Figure 6)
NOTE: To create a flat working surface
between tables, you may need to lift
the corners of add-on table when nuts
are tightened.
PAGE 2 OF 9
MOBILE ADD-ON TABLE INSTRUCTIONS
Starter Leg
Brace Bolt
Long Brace
(2) 3/8 x 3/4" Bolts
and Nuts
Short Brace
3. Unfold remaining short braces on add-on table
and line up with leg assembly on starter table.
Remove starter leg brace bolts. Install braces
from both tables to leg assembly using the
same starter leg brace bolts. (See Figure 7)
Figure 7
4. After all starter and add-on tables have been
assembled, all nuts can be tightened fully.
Add-On
Table
1021 IH-5785