Parts And Components; Before Use; Operation - cecotec SPIRALCHEF 400 Manual Del Usuario

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1.
1. Pusher
2. On/off switch
3. Collecting container
4. Inlet mouth
5. Fixing base
Fig. 2.
1. Fine cut attachment
2. Medium cut attachment
3. Thick cut attachment
4. Cutting blade

2. BEFORE USE

Take the product out of the box and remove all packaging materials.
Make sure the product is in good conditions. If any sign of visible damage is observed, contact
immediately with our official Technical Support Service.
Place the appliance on a clean, stable and flat surface.
Clean the appliance before using it for the first time.
Connect it to a power supply.

3. OPERATION

Note: Do not use the appliance for more than 1 minute.
Place the device on a flat, stable surface.
Assemble the desired cutting blade on the fixing base.
Check that the blade and the toothed wheels are correctly positioned and then check that the
feed tube is properly closed. If it is not properly closed, once the receiving tray is in place, check
that the unit is turned off and plug it into a power supply.
Pierce the vegetables with the pusher.
The vegetable must have a diameter of between 2.05 cm and a maximum of 6 cm.
Put the vegetable into the tube using the pusher. Once it reaches the cone of the blade, start
22
SPIRALCHEF 400