Promate SolarTrail-1 Guia Del Usuario página 5

2. Use the measure card to drill 2 holes of Ø6mm in correct position.
3. Fix 2 expansion plugs into the holes.
4. Fix screws to the expansion plugs with a spare space.
5. Hang the notch onto the screws and fasten the lamp.
6. Press the button to turn it on. You only need to press once for it to work
permanently.
7. When the battery capacity is above 30%, the lamp will automatically turn on
to full brightness (240lm) when motion is detected in the working range, and
then turn to weak brightness (front light on and back light on) when there is
no motion for 10 seconds.
8. When the battery capacity is below 30%, the lamp will automatically turn on
to full brightness (240lm) when motion is detected in the working range, and
then turn to weak brightness (front light off and back light on) when there is
no motion for 10 seconds.
Notice
• This is a solar-powered lamp; please install it in a location where it can get
enough sunshine.
• Please note the lighting time depends on sunshine duration and weather.
• The lamp will light up automatically at dusk.
• Built-in intelligent IC overcharge, over-discharge, and over-voltage protection.
• The lamp is equipped with an internal lithium battery; please do not replace it
by yourself, and don't dispose it with household garbage to avoid problems.
English
4