Alcad SCM-040 Guia De Inicio Rapido página 8

VIDEOPORTERO DIGITAL - DIGITAL VIDEODOOR ENTRY SYSTEMS - VIDÉOPORTIER NUMÉRIQUE
INSTRUCCIONES DE PROGRAMACIÓN - PROGRAMMING INSTRUCTIONS - INSTRUCTIONS DE PROGRAMMATION
DESCRIPCIÓN - DESCRIPTION - DESCRIPTION
CC1
J1
A B
R1
Programming the monitor should be carried from the system's main entrance panel. Bear in mind that in systems with pushbutton
entrance panels, the audio unit of the main entrance panel must have the J1 jumper installed. In systems with keypad entrance
panels, the panel must be configured as the main panel (see the entrance panel instructions).
The programming code is stored in the connection bracket, that means that there is only needed one monitor in order to program
all the brackets. Please don´t forget to program again the connection bracket if you replace it.
In installations where several devices (monitors or telephones) are associated to the same call line (in parallel), each device should
be programmed individually and with the same code (the same push-button).
Main entrance panel
Programing switch
J1
GRF-008
19
J1 J2
BUS
15 V
– + IN
9 10 11 12 22 16 18 7 D1 D2 D3
Audio unit
Digital monitor
1 2 3
4 5 6
7 8 9
C 0
Main entrance panel
Lock release
Entrance panel configured as the
main panel.