Alcad SCM-040 Guia De Inicio Rapido página 9

VIDEOPORTERO DIGITAL - DIGITAL VIDEODOOR ENTRY SYSTEMS - VIDÉOPORTIER NUMÉRIQUE
PASOS PROGRAMACIÓN
1
2
3
4
5
6
7
Nota :
PROGRAMMING STEPS
1 Connect the monitor cable strip in the connections bracket.
2 For greater ease, you can lean the monitor against the connections bracket. To do so, fit the upper right-hand tab of the connections
bracket into the central slot on the base of the monitor.
3 Connect the cord between the monitor base and the receiver. You will hear a continuous tone with the PROG switch in the ON
position.
4 Turn the PROG switch to the OFF position (4.1), the tone stops. Turn the switch back to the ON position (4.2).
5 Press the lock release button. The audio and the video will be activated between the monitor and the main panel. The monitor is
ready to receive the code.
6 From the main entrance panel, make the call to the house or flat when monitor to be programmed is installed. The panel emits a
confirmation tone. The connection bracket has been programed.
7 Check the operation of the monitor (call, audio and door opening). If the monitor does not function correctly then repeat the process
from Step 4.
Note: Maximum time limit of 1 minute between Steps 4 and 5 and between 5 and 6. The system warns by means of a series of beeps
of the end of the time limit between Steps 5 and 6; repeat Step 5 to have another minute. If the time limit is exceeded the process must
be repeated from Step 4.
ETAPES DE PROGRAMMATION
1
2
3
4
5
6
7
Remarque: