Measuring Volume - Stanley TLM99 Manual Del Usuario

GB 5. Measure the length.
• Position the tool at one end of the target and
point the laser dot across the length. (Figure
#2 shows where to position the tool if you are
measuring from the bottom of the tool.)
• Click to display the length measurement on
the second line of the display window.
6. View the Area measurement at the bottom of the
display window (Figure

Measuring Volume

You can measure the volume of a room or object.
1.
Click (Figure
2. The tool will measure the distance from the bottom
of the tool to the wall or object (Figure
To measure from the top of the tool instead of the
bottom (Figure
On the display window, the tool icon will change
from to
3. Click twice to show
window (Figure
4.
Measure the width.
• Point the top of the tool at one side of the target
(room or object).
• Position the tool at one end of the target and
point the laser dot across the width. (Figure
#1 shows where to position the tool if you are
measuring from the bottom of the tool.)
• Click to display the width measurement at the
top of the display window.
5. Measure the length.
• Position the tool at one end of the target and
point the laser dot across the length. (Figure
#2 shows where to position the tool if you are
measuring from the bottom of the tool.)
• Click to display the length measurement on
the second line of the display window.
6
#3).
E
#5) to turn on the tool.
A
F
#2), hold for 2 seconds.
F
(Figure #5).
E
on the display
#4).
E
6. Measure the height.
• Positon the tool at one end of the target and
point the laser dot across the height. (Figure
G
#3 shows where to position the tool if you are
measuring from the bottom of the tool).
• Click
the third line of the display window.
7. View the Volume measurement at the bottom of the
display window (Figure
Adding Measurements
You can add two measurements to get a total
measurement of the two distances.
1. Click
2.
The tool will measure the distance from the bottom
#1).
of the tool to the wall or object (Figure
To measure from the top of the tool instead of the
bottom (Figure
On the display window, the tool icon will change
from
3.
Point the laser at the top of the tool (Figure
toward the wall or object whose distance you need
to measure.
4. Click
the wall or object.
5. Indicate that you want to add this measurement to
H
the next measurement.
• On the TLM99 keypad, click
#7).
A
• On the TLM99s or TLM99si keypad, click
(Figure
6. Point the laser at the top of the tool toward the next
wall or object.
H
7. Click
previous measurement.
8.
View the total of the two measurements at the
bottom of the display window (Figure
to display the height measurement on
#3).
E
(Figure #5) to turn on the tool.
A
#2), hold
F
to (Figure #5).
E
to measure the distance from the tool to
#1).
B
to measure the distance and add it to the
H
#1).
F
for 2 seconds.
#1)
A
(Figure
#3).
E