EUROM VENTO 9 Manual De Instrucciones página 10

 Check that the fan rotates freely if you turn it by hand.
 Open the grid locking ring a little by loosening the screw a bit. Place the front grid on the
rear grid so that the grid locking ring correctly encloses the edges of the grids; the grids
firmly against each other! Then tighten the grid locking ring firmly with the screw. Check
that everything is properly lined up.
 Vento 9, 12 & 16: Run the electric cable through the hole in
the foot. Mount the pedestal on the foot, so that the
protrusions on the pedestal enter the cut aways in the foot.
Now screw the pedestal to the foot; the electrical cable will
now run through its guides (see fig.).
 Vento 16SR: Push the lower section of the stand into the
hole in the base and and screw it to the bottom of the base
with the 4 screws with washers. Screw the top section of the
stand firmly to the lower section, clockwise.
10
ASSEMBLY
A. front grid
B. grid locking ring
C. fan
D. grid mount
E. rear grid
F. motor shaft
G. stand protrusion
H. foot cutaway
I. pedestal
J. foot
K. fan mounting knob
L. shaft pin
Unplug from the wall socket!
 Remove the fan mounting knob (only
Vento 12&16/16SR) and the grid mount
from the motor shaft.
 Position the rear grid on the appropriate
pins. Screw it tight with the grid mount.
 Push the fan as far as possible onto the
motor shaft. Vento 12 and 16(SR):
ensure that the pins enter the grooves
and tighten the fan with the fan mounting
knob by tightening it anti-clockwise.