Cleaning And Maintenance; Problems And Solutions - EUROM VENTO 9 Manual De Instrucciones

13

CLEANING AND MAINTENANCE

Switch the fan off and remove the plug from the socket if you wish to clean the device or
perform maintenance.
The fan only needs general, exterior maintenance. Dust it regularly with a soft cloth or duster or
use a vacuum cleaner with a soft brush to clean. If it is very dirty, open the grille and clean
grilles and blades using a soft, damp cloth and a mild household cleaning agent. Dry everything
thoroughly and allow the fan to dry properly before reassembling and using again. Ensure that
water does not come into contact with anything other than the grille and blades. Never rinse or
spray the fan!
In order to prevent material discolouration or deformities, never use aggressive or corrosive
(cleaning) products.
Rub a little oil on the motor shaft at the end of the season to prevent rust.
If the fan is to be stored at the end of the season, repack in its original packaging: this offers the
best protection. Store it in a safe and dry place that is not subject to extremes of heat or cold.

PROBLEMS AND SOLUTIONS

The fan blades do not rotate even though the device is switched on
 Is the plug in the socket?
 Is there power to the socket?
 Is the blade blocked, e.g. by damage, a deformity on the grille or a foreign object?
There is strange noise when starting
 Check to ensure the blades are placed as far over the motor axle as possible.
 Check whether the blades have become deformed and are touching the protective grille.
Warning: Repairs must be carried out by qualified engineers. This also applies to replacing or
repairing the electrical cable and plug. Please request original parts if the device needs to be
repaired.
If the device is subjected to modifications or repairs are carried out by unqualified persons, the
guarantees from the supplier, importer and manufacturer will become null and void.