Adjusting The Connecting Cable - Stihl KMA 130 R Manual De Instrucciones

7 Adjusting KombiMotor for User
► If the connecting cable is fitted through the
upper left opening (1) or the upper right open‐
ing (2):
► Open the press studs (5).
► Lay the connecting cable over the shoulder
strap (6).
► Close the press studs (5).
► If the connecting cable is fitted through the
lower left opening (3) or the lower right open‐
ing (4): Seal the opening you use (3 or 4) with
the hook and loop fastener (7).
► Arrange the connecting cable so that it is as
short as possible without hindering your work.
7.2.2 Fitting and Adjusting the Carrying Sys‐
tem
► Put the battery on your back.
► Close buckle (2) on the waist belt.
► Close buckle (1) on the chest strap.
3
► Tighten the straps until the waist belt fits
snugly on your hips and the back padding is
against your back.
► Thread the end of the waist belt through the
loop (3).
► Fit the hip pad as described in the instructions
supplied with the hip pad.
2
0458-805-9821-C
1
1
► Adjust the strap (1) so that the carabiner (2) is
about a hand's width below your right hip.
7.3 Using with AP Belt Bag with
Connecting Cable
7.3.1 Attaching the "Belt bag AP with con‐
necting cord"
1
2
► Open the Velcro® fastening on the strap (1)
and pull the strap (1) out of the ring (2).
► Feed strap (1) through belt (3).
3
1
► Feed strap (1) back through the ring (2) and
the belt (3).
► Close the Velcro® fastening on the strap (1).
► Push battery (4) as far as it will go into the belt
bag (5).
A short beep will sound.
► Secure battery (4) with the Velcro® fasten‐
ing (6).
7.3.2

Adjusting the Connecting Cable

The connecting cable can be fitted and adjusted
to suit the user's size and the application.
English
1
3
1
4
5
6
25