Alarms - Saci EASYTRONIC Manual De Instalación Y Mantenimiento

The system will initially stop the affected pump for a period of 5 minutes. After this time it
will re-enable it so that it can function normally again. If a fault occurs again, this time it will
stop the pump for 10 minutes, re-enabling it normally after this time. This auto-reset loop with
increased time will occur until the system understands that there is a non-temporary problem
in the pump or installation that will prevent the pump from working. In this case, the pump will
remain disabled indefinitely until the direct intervention of the installer.
In the settings of the detection against dry running, we can set a fixed reset time, so that the
stops for detection of work without water will not have an incremental reset time, but always
the same. This fixed reset time is configurable by the user.

14. ALARMS

MESSAGE
TRANSDUCER FAILURE
TANK OVERFILLED
AUTOMATIC STOP
MANUAL STOP
36
CAUSE
The pressure transducer
is missing, damaged, or
not wired correctly.
Digital input 4 has
been activated.
Digital input 1 has been
activated.
The STOP/AUTO
button was pressed
SOLUTION
Check that the transducer is
connected with the correct polarity
to the specific input for the pressure
transducer. If the error message
persists, it may mean that the
transducer is defective and must be
replaced.
In a dirty water lifting system, it
indicates that the level float in charge
of indicating the over-level of the
tank is active, therefore there is a
danger of overflow.
In a tank-fill booster system, it
indicates that the target tank is about
to overflow.
This message will only be displayed
in a BOOSTER SET or BOREHOLE
PUMP type of application, and
indicates that the pump water supply
tank is empty.
The intervention of the installer has
blocked the device, therefore the
pumps are stopped and disabled for
their automatic operation. Press the
STOP/AUTO button to re-enable the
autonomous device operation.