Trust START ACM-2300-HC Manual Del Usuario página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
EN
ACM-2300-HC BUILD-IN SWITCH
10. Set the desired switch-off time
Set the switch-off time to the desired position with a flathead screwdriver. The switch-off time can
also be changed after the switch is paired to a Trust Smart Home transmitter.
0m: No OFF signal is sent automatically.
1m, 10m, 1h and 4h: An OFF signal is automatically sent after 1 minute, 10 minutes, 1 hour or 4 hours.
11. Placing the receiver
Place the receiver in the ceiling box. Mount the lights back in place.
Make sure that you can always reach the receiver, for example, to reset it, or to register a new
transmitter.
Make sure no stripped parts of wires touch each other.
Deleting a single transmitter code
A
Press for about 1 second on the Connect button. The pairing mode will be active for 12 seconds and
the LED indicator on the receiver will flash slowly.
B
Send while the pairing mode is active with the connected Trust Smart Home transmitter an
OFF signal. If necessary, consult the instruction manual of the transmitter.
C
The LED on the module will flash to confirm that the code has been removed.
Repeat this procedure to delete several transmitters from the receiver.
Erase entire memory
A
Press the Connect button for about 8 seconds until the LED indicator flashes quickly.
B
When the LED indicator flashes rapidly, press the Connect button again shortly to confirm that you
want to completely erase the memory.
C
The LED on the module flashes to confirm that the memory has been erased.
10

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Start-line acm-2300-hc

Tabla de contenido