Step 8: Pump - Connecting Cables (Amd); Step 9: Fans - Connecting Cables (Amd) - ekwb EK-AIO Elite 360 D-RGB Manual De Instalación

EK-AIO Elite 360 D-RGB / EK-AIO Elite 280 D-RGB
UNC 6-32 x 34 mm
(12x / 8x)
4-pin Connector
D-RGB
Connector
VDG Connector
EK-AIO Elite 360 D-RGB / EK-AIO Elite 280 D-RGB
Option 1
Use the UNC 6-32 x 34mm screws to attach the
preassembled radiator-and-fans setup with the
remaining three / two fans (to have six / four
fans in total) to the PC chassis.
The orientation of the fans is crucial for
achieving the best performance of the radiator.
Install the fans so that they will push the air
through the radiator. To be sure about the fan
orientation, you can look at the position of
the EK logo on the side of the fan - it must be
oriented the same way on both the upper and
lower set of fans. It is also recommended that
cables of all fans are facing the same direction
for easier cable management.
Option 2
If there is not enough space inside your PC
chassis to place all six / four fans on the radiator,
you may position the remaining three / two
somewhere else inside your PC.
In that case, use the UNC 6-32 x 6mm screws
to attach the preassembled radiator and the
fans to the PC chassis.
STEP 8: PUMP – CONNECTING CA-
BLES (AMD)
Step A:
Plug the 4-pin PWM connector of the pump
into the motherboard.
Do not use the same HUB that fans are
connected to - the rotational speed (RPM)
of the fan and the pump should be regulated
separately.
D-RGB Header
RGB Header
D-RGB Header (7x)
HUB
4-pin PWM Header (7x)
SATA
4-pin "Red" PWM Header
PWM Header to
Motherboard (1x)
D-RGB Header to
Motherboard (1x)
Fan D-RGB LED Light
Connector
Fan Connector
- 11 -
Step B:
Plug the 3-pin connector of the pump's
D-RGB LED light into the D-RGB HEADER on
the motherboard or into one of the D-RGB
(Addressable RGB) HEADERS on the HUB. The
LEDs will work if the pin layout on the header is
as follows: +5V, Data, Empty, Ground. With
some motherboards, you can alternatively
use a VDG connector instead of the D-RGB to
connect the LEDs.
Please ensure that the arrow
indicated on the connector
plugged into the +5V line as
indicated on your motherboard. If
you put LED Diode to the 12V RGB
HEADER you can damage the LEDs.
Connector is the same on D-RGB
and RGB versions, but D-RGB
version has 3 cables from connector
to PCB; RGB version has 4 cables. If
you connect D-RGB led to ordinary
RGB header you can damage your
motherboard or LED strip.
STEP 9: FANS – CONNECTING
CABLES (AMD)
is