Optional Step! Applying The Thermal Compound; Support And Service; Social Media - ekwb EK-AIO Elite 360 D-RGB Manual De Instalación

Fan
Connector
D-RGB Header
RGB Header
EK-AIO Elite 360 D-RGB / EK-AIO Elite 280
D-RGB
Step A:
Plug all of the 4-pin PWM fan connectors into
PWM headers on the HUB (x6 / x4). Make sure
the red PWM header on the HUB is always used.
Plug the PWM connector from the HUB
directly into the CPU fan header on the
motherboard. Always use the CPU fan header
if possible.
Step B:
Plug the D-RGB connectors of the fans into the
D-RGB HEADERS on the HUB (x6 / x4).
Plug the D-RGB connector from the HUB
directly into the motherboard.
Non-abrasive
IHS
cloth

7. SUPPORT AND SERVICE

For assistance please contact: http://support.ekwb.com/
EKWB d.o.o.
Pod lipami 18
1218 Komenda
Slovenia - EU

8. SOCIAL MEDIA

EKWaterBlocks
@EKWaterBlocks
ekwaterblocks
EKWBoffi cial
ekwaterblocks
- 12 -
OPTIONAL STEP! APPLYING THE
THERMAL COMPOUND
This step is relevant only in the case of a
second installation of AIO or if you have
damaged the pre-applied paste on the
backside of the pump unit! For the fi rst
installation, you don't need to apply the
additional thermal compound to the CPU's
contact surface!
Wipe the CPU's contact surface (using a
non-abrasive cloth or a Q-tip as shown in the
sample image). On a clean IHS, apply a line
of thermal compound and spread it over the
whole CPU heat spreader (IHS) with a credit
card or something similar.