Cisco Systems Catalyst 2960 Serie Guía De Inicio página 15

Chapter 1 Getting Started Guide
Resetting the Switch
Caution
78-16879-02
This section describes how to reset the switch by rerunning Express Setup. These
are reasons why you might want to reset the switch:
You installed the switch in your network and cannot connect to it because you
•
assigned the wrong IP address.
You want to clear all configurations from the switch and assign a new IP
•
address.
You are trying to enter Express Setup mode, and the switch LEDs start
•
blinking when you press the Mode button (which means that the switch is
already configured with IP information).
Resetting the switch deletes the configuration and reboots the switch.
To reset the switch:
Press and hold the Mode button. The switch LEDs begin blinking after about
•
3 seconds. Continue holding down the Mode button. The LEDs stop blinking
after 7 more seconds, and then the switch reboots.
The switch now behaves like an unconfigured switch. You can enter the switch IP
information by using Express Setup as described in the
section on page 1-2.
"Running Express Setup"
Catalyst 2960 Switch Getting Started Guide
Resetting the Switch
1-9