Using The Appliance; Replacing The Dustbag - Philips Performer FC9153/11 Manual Del Usuario

Carpet setting:
2 Push the rocker switch again to make the brush strip disappear into the nozzle housing.The
wheel will be lowered automatically (fig. 8).
Crevice tool, small nozzle (specific types only) and small brush
1 Connect the crevice tool (1), the small nozzle (2) or the small brush (3) directly to the
handgrip or to the tube (fig. 9).
Accessory holder
The accessory holder can be snapped onto the handgrip (fig. 10).
The accessories can be stored in the accessory holder by pushing them into the holder.To detach
the accessories, pull them out of the holder.
You can store two accessories at a time in the accessory holder:
Crevice tool and small nozzle (fig. 11).
Please note the way in which the small nozzle must be placed in the accessory holder.
Crevice tool and small brush (fig. 12).

Using the appliance

1 Pull the cord out of the appliance and put the mains plug in the wall socket.
2 Switch the appliance on by pressing the on/off button on top of the appliance with your foot
(fig. 13).
During vacuum cleaning you can adjust the suction power by means of the knob on top of
the appliance (fig. 14).
- Use maximum suction power for vacuum cleaning very dirty carpets and hard floors.
- Use minimum suction power for vacuum cleaning curtains, table carpets, etc.
If you want to pause for a moment, you can park the tube in a convenient position by
inserting the ridge on the nozzle into the parking slot (fig. 15).
Storage
1 Switch the appliance off and remove the mains plug from the wall socket.
2 Rewind the mains cord by pressing the cord rewind button (fig. 16).
3 You can put the appliance in upright position and attach the nozzle to the appliance by
inserting the ridge on the nozzle into the slot (fig. 17).
4 Always put the Tri-Active nozzle in the carpet setting when you store it and prevent the side
brushes from becoming bent (fig. 8).

Replacing the dustbag

Always unplug the appliance before replacing the dustbag.
Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i.e.
even when the nozzle is not placed on the floor (fig. 18).
1 Open the cover by pulling it upwards (fig. 19).
2 Lift the dustbag holder out of the appliance (fig. 20).
Make sure you hold the dustbag upright when lifting it out of the appliance.
ENGLISH 7