Eldom auro NU100 Manual De Instrucciones página 11

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
OPERATION
All changes in the settings are confirmed with an audio signal.
- Set the rotating nozzle in the cover (1).
- Connect the device to the power supply compatible with the parameters stated above. The
appliance will enter the stand-by mode. No function is active, and the display is switched off.
ON/OFF (SWITCHING ON / SWITCHING OFF)
Pressing the button (A) will cause the display to activate. The humidifier will start running at the
lowest level of humidification, with the fan motor running. The humidity level is displayed. Pressing
the button (A) again will switch off the unit and make it enter the stand-by mode.
SPRAY (MIST)
The appliance is fitted with a three-stage control of humidification. The level of humidification is
changed with the button (B). The changes are indicated with the number of displayed segments.
TIME (CLOCK)
This function allows to set the time after which the appliance will automatically switch off. This
function may be started only when the appliance is on. Only full hours may be set, 1 to 12.
The function is activated with the button (C). Activation of the function is indicated with the icon
„C" on the display. The appliance does not show the passing time. Every consecutive pressing of the
button (C) will extend the time.
HUMIDITY (HYGROMETER)
This function allows to set the level of humidity from 40–90% in 5% steps. The appliance will start
after about 3 seconds of entering the settings. It will switch off when the current humidity is higher
than the set level. The function will activate when the current relative humidity is at least 2% lower
than the set value. Activation of the function is indicated with the icon „D" on the display.
Due to external conditions, an error may occur between the actual and the displayed values of
humidity of up to about 5%
PURYFI (PURIFICATION)
The air purification function is activated with the button (E). Activation of the function is indicated
with the icon „E" on the display.
SLEEPMODE (NIGHT MODE)
The night mode is activated with the button (F). The display is dimmed down in this mode, and the
appliance will automatically activate the "PURYFI", "ANION", "HUMIDYTY" (65%) functions and
will set the second stage of humidification.
ANION (IONISATION)
The ionising function is started with the button (G). Activation of the function is indicated with the
icon „G" on the display.
CONFORTABLE (COMFORT MODE)
The comfort mode is activated with the button (H). In this mode, the appliance will automatically
activate the "PURYFI", "ANION", "HUMIDYTY" (65%) functions and will set the second stage of
humidification.
WATERLESS (NO WATER)
This symbol
will be displayed when water is not present in the container. The appliance will
switch off automatically.
EN
11

Publicidad

Tabla de contenido
loading

Tabla de contenido