Publicidad
b)
If you discover damage or irregular operation,
immediately switch the device off and report it to
a supervisor without delay.
c)
If there are any doubts as to the correct operation
of the device, contact the manufacturer's support
service.
d)
Only the manufacturer's service point may repair the
device. Do not attempt any repairs independently!
e)
In case of fire, use a powder or carbon dioxide
(CO
) fire extinguisher (one intended for use on live
2
electrical devices) to put it out.
f)
Please keep this manual available for future reference.
If this device is passed on to a third party, the manual
must be passed on with it.
g)
Keep packaging elements and small assembly parts in
a place not available to children.
h)
Keep the device away from children and animals.
2.3. PERSONAL SAFETY
a)
The device can be handled only by physically fit
persons who are capable of handling it, properly
trained, familiar with this manual and trained within
the scope of occupational health and safety.
b)
To prevent the device from accidentally switching on,
make sure the switch is on the OFF position before
connecting to a power source.
c)
The device is not a toy. Children must be supervised to
ensure that they do not play with the device.
2.4. SAFE DEVICE USE
a)
Do not overload the device. Use the appropriate tools
for the given task. A correctly-selected device will
perform the task for which it was designed better and
in a safer manner.
b)
Make sure the plug is disconnected from the socket
before
attempting
any
adjustments,
accessory
replacements or before putting the device aside.
Such precautions will reduce the risk of accidentally
activating the device.
c)
Keep the device in perfect technical condition. Before
each use check for general damage and especially
check for cracked parts or elements and for any other
conditions which may impact the safe operation of
the device. If damage is discovered, hand over the
device for repair before use.
d)
Keep the device out of the reach of children.
e)
Device repair or maintenance should be carried out by
qualified persons, only using original spare parts. This
will ensure safe use.
f)
To ensure the operational integrity of the device, do
not remove factory-fitted guards and do not loosen
any screws.
g)
When transporting and handling the device between
the warehouse and the destination, observe the
occupational health and safety principles for manual
transport operations which apply in the country where
the device will be used.
h)
Clean the device regularly to prevent stubborn grime
from accumulating.
i)
The device is not a toy. Cleaning and maintenance may
not be carried out by children without supervision by
an adult person.
j)
It is forbidden to interfere with the structure of
the device in order to change its parameters or
construction.
8
k)
Keep the device away from sources of fire and heat.
l)
Do not overload the device.
m)
Do not cover the ventilation openings!
n)
Under no circumstances should the housing be
opened.
o)
Do not store heavy, poisonous or corrosive objects in
the device.
p)
In order to avoid damaging the compressor during
transport, the fridge should not be tilted by more than
45°.
q)
Do not use the fridge in unheated rooms and in
locations with high air humidity.
r)
There is a risk of a child getting stuck inside the
device. Before storing the device withdrawn from use,
it is necessary to dismantle the door and to leave the
shelves in their place, so that children cannot easily
enter the interior.
s)
Do not use mechanical devices to accelerate the
process of cooling!
t)
Do not damage the refrigerant circuit.
u)
Do not use any electrical appliances inside the cooler
other than those specified by the manufacturer.
v)
It is a free-standing device, and is not suitable to be
built into cabinets, used in campers or RVs, it does not
co-operate with inverters.
ATTENTION! Despite the safe design of the device
and its protective features, and despite the use of
additional elements protecting the operator, there is
still a slight risk of accident or injury when using the
device. Stay alert and use common sense when using
the device.
3. USE GUIDELINES
The device is intended solely for the storage of wine.
The user is liable for any damage resulting from
unintended use of the device.
3.1. DEVICE DESCRIPTION
7
1
2
3 4
5
6
1.
Housing
2.
Shelves for beverages
3.
Adjustable foot
4.
Additional door bracket
5.
Crossbar to secure the bottles
6.
Door with a display window
7.
Door hinge
Rev. 01.12.2020
3.2. PREPARING FOR USE
APPLIANCE LOCATION
The ambient temperature should not exceed the range of
5-32°C and the relative humidity should not exceed 85%.
Ensure good ventilation in the room in which the device
is being used. Keep a minimum distance of approx. 13 cm
from the rear and side walls of the device. The device should
always be used when positioned on an even, stable, clean,
fireproof and dry surface, and be out of the reach of children
and persons with limited mental and sensory functions.
Position the device such that you always have access to the
power plug. The power cord connected to the appliance
must be properly grounded and correspond to the technical
details on the product label. Level the device using the
adjustable feet. Before the first use, remove and wash all
accessories; wash the device inside and dry it thoroughly.
ASSEMBLING THE APPLIANCE
After transporting the device, do not turn it on for approx.
8 hours before connecting it to the power source - the
refrigerant must be evenly distributed around the system to
prevent possible failure of the cooling system as the result
of the device being tilted from the vertical axis beyond 45°.
3.3. DEVICE USE
3.3.1 THE CONTROL PANEL
The control panel is located at the front, in the upper part of
the device; it is accessible when the door is opened.
A
B
C
D
E
A.
the device on/off button (press and hold for 5 seconds
to turn the device on or off)
PLEASE NOTE: when first switched on, the compressor
in the appliance may run continuously, and the
cooler inside may give off an unpleasant smell. This
is normal and is not a defect of the device! Over
time, the unpleasant smell should disappear, and
when the device desired temperature is reached,
the compressor will turn off. During this time, avoid
opening the cooler door frequently or placing bottles
inside.
IMPORTANT: after switching the device off or
disconnecting it from the power source, wait at least 5
minutes before reconnecting or switching it on.
B.
On/off button, cooler interior light and temperature
unit change (press to turn on or off the light; press and
hold for 5 seconds to change the temperature units
from Celsius to Fahrenheit - oC/oF - the selection of
the appropriate unit will be highlighted on the right
hand side of the temperature display )
C.
display the current temperature value in the cooler
D/E. increase/decrease
the
temperature
within
available range (pressing the button once shows
the currently set temperature, and pressing it again
increases/decreases the value of the set temperature
by 1 degree each time)
.
PLEASE NOTE: to view the desired temperature, press
the button D or E, and the required temperature value
will be displayed for approx. 5 seconds)
Rev. 01.12.2020
3.3.2. SUGGESTIONS FOR OPTIMAL USE
•
Grill shelves (trays) for beverage bottles are adapted
to store standard wine bottles, i.e. 0.75 L, and it is on
this this basis that the maximum number of stored
bottles has been calculated, although larger bottles
can also be stored in the cooler.
6
11
5
8
5
6
3
3
•
For the safety of the user and to secure the stored
beverages, the grid shelves (trays) have been designed
in such a way that they cannot be removed in full,
when the bottles are stacked. For optimal access, just
slide the appropriate tray out to 1/3 of its length.
•
Adding several bottles at once will take more time to
cool than when the bottles are added individually.
•
Make sure that the cooler door is tightly closed and
that nothing prevents it from closing (e.g. insufficiently
inserted shelf).
•
Wine stored at higher temperatures ages faster and
may lose flavour and aroma. On the other hand, if
the storage temperature is too low, it may cause the
accumulation of harmful deposits inside the bottles.
Exposing the wine to light, vibrations, or fluctuations
in temperature or humidity harms its taste, bouquet of
aromas and may lead to spoilage. The ideal humidity
for wine storage is 60-70%, while the temperature
depends on the type of wine:
Type of wine
Storage temperature (°C)
red
15.5 – 18.5
white
10 - 15
sparkling/champagne
7.2 – 9.5
rosé
9.5 – 10.5
mature/good vintage
13
the
•
When the bottle is opened, the wine comes into
contact with air, so store the opened bottle in such
a position that the smallest possible surface of the
wine comes into contact with the air. After opening
the bottle, the wine, it is suitable for consumption for
2 more days for delicate white wines or 3 for red wines
with a strong, rich taste.
9
Publicidad
