Bort select Manuzip Manual De Instrucciones página 8

EN
Fitting instructions
Before putting on, bend the aluminium splint to the desired shape. Open the zip
and place the support on the metacarpophalangeal joint affected and guide the
thumb through the intended thumb opening at the same time. The aluminium splint
runs along the surface of the palm. Finally, close the zip. The Stabilo fleece strap
included can be fitted individually dosed. For this, attach the Stabilo fleece strap to
the velour on the support intended for this purpose using the narrow Velcro strip.
The Stabilo fleece strap can then be twisted around the wrist circumferentially.
Removal
To remove the support, please open the zip and loosen the Stabilo fleece strap.
Grasp the splint in the palm area and pull the support off over the fingers. Close the
Velcro fastener in order to avoid early wear to the Velcro surface.
Material composition
Polyamide (PA), elastodiene/latex (LA), viscose (CV)
The sewn in textile label provides the precise material composition.
The product contains latex and can trigger allergic reactions.
Cleaning information
Delicate wash Do not clean chemically Do not bleach
Do not dry in a tumble dryer Do not iron
Remove the aluminium splint before washing. Close the Velcro fastener in order to
avoid damaging other items of clothing. Do not use fabric conditioner. Stretch back
into shape and dry in the fresh air.
Guarantee
The legal regulations of the country in which you acquired the product apply to the
purchased product. Please contact your specialist retailer if you suspect a warranty
08