Uline H-3620 Guia De Inicio Rapido página 2

E
Figure 5
To start application:
1. Place applying roller (E) on
surface, depress trigger and pull
dispenser. (See Figure 5)
NOTE: A slight delay may
take place before adhesive
is applied when starting a
new application.
1. Replace roller (A) with 1/4" wide
roller from kit. Secure with screw.
Place the drive gear spacer (B)
from kit on tape core reel.
(See Figure 8)
2. Remove rewind hub (C), spring
retainer (E), and spring (F).
(See Figure 8)
3. Assemble outer rewind disk (D),
spring (F), spring retainer (E), and
inner rewind disk (G). Position
inner rewind disk (G) and outer
rewind disk (D) as shown.
(See Figure 8)
PAGE 2 OF 6
OPERATION
Figure 6
To end application:
2. Keep roller on surface, release
trigger and pull dispenser to
break adhesive. (See Figure 6)
ADAPTER KIT FOR 1/4" TAPE (OPTIONAL)
Figure 8
A
B
1-800-295-5510
uline.com
G
Figure 7
liner tension adjustment:
3. Press down (G) black center
tension adjuster. Turn (H)
clockwise to tighten the tension
of the liner. Turn (I) to loosen.
(See Figure 7)
C
D
E
F
Adapter Kit
for 1/4" Tape
G
1020 IH-3620