ASROCK P67 Pro3 SE Manual De Instrucciones página 25

2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATAII Connectors
(SATA2_2: see p.2, No. 8)
(SATA2_3: see p.2, No. 11)
(SATA2_4: see p.2, No. 7)
(SATA2_5: see p.2, No. 12)
Serial ATA3 Connectors
(SATA3_0: see p.2, No. 9)
(SATA3_1: see p.2, No. 10)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB8_9)
(see p.2 No. 22)
(9-pin USB10_11)
(see p.2 No. 21)
(9-pin USB12_13)
(see p.2 No. 20)
ASRock P67 Pro3 SE Motherboard
These four Serial ATAII (SATAII)
SATA2_4 SATA2_2 connectors support SATA data
cables for internal storage
devices. The current SATAII
interface allows up to 3.0 Gb/s
SATA2_5 SATA2_3
data transfer rate.
These two Serial ATA3 (SATA3)
SATA3_0
connectors support SATA data
cables for internal storage
devices. The current SATA3
SATA3_1
interface allows up to 6.0 Gb/s
data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
Besides six default USB 2.0
USB_PWR
P-9
ports on the I/O panel, there
P+9
GND
DUMMY
are three USB 2.0 headers on
1
this motherboard. Each
GND
USB 2.0 header can support
P+8
P-8
USB_PWR
two USB 2.0 ports.
USB_PWR
P-11
P+11
GND
DUMMY
1
GND
P+10
P-10
USB_PWR
USB_PWR
P-13
P+13
GND
DUMMY
1
GND
P+12
P-12
USB_PWR
25